Rear Impact Guard Requirements for Trailers
Under 49 CFR 393.86(a), each trailer and semitrailer with a GVWR of 10,000 pounds or more, manufactured on or after January 26, 1998, must have a rear impact guard meeting FMVSS No. 223, and the vehicle must meet FMVSS No. 224 at a minimum.
Figures and rules on this page were checked against the official sources listed below as of November 11, 2026. Rules change; confirm with the official source before you file.
Size rules
The guard's horizontal member must reach within 4 inches of each side of the vehicle without sticking out past it, and its bottom edge may not be more than 22 inches above the ground at any point across its width.
Exceptions
Paragraph (a) does not apply to pole trailers, pulpwood trailers, low chassis vehicles, special purpose vehicles, wheels back vehicles, road construction controlled horizontal discharge trailers, or trailers towed in driveaway-towaway operations.
Older equipment
Trailers built before January 26, 1998 fall under the rule's separate rear end protection provisions; read 393.86(b) for those units.
About USAFE Services
USAFE Services is a private filing company and not a government agency. We are registered with FMCSA as a Supporting Company, Filer #5191541. Questions? Call 702-988-9990.
Need this filed for you?
USAFE Services handles the filing end to end, or call and we will walk you through what your record needs.
Frequently asked questions
Related pages
Sources
USAFE Services is registered with FMCSA as a Supporting Company, Filer #5191541.